Daewoo CIELO EURO III Manual page 518

1F – 348 ENGINE CONTROLS
Circuit Description
The engine control
module (ECM) monitors the ignition voltage on the igni-
tion feed circuit to terminal K18 1.5L
SOHC at the CM. A system voltage Diagnostic
Trouble Code (DTC) will set whenever the voltage is be-
low a calibrated value.
Conditions for Setting the DTC
D Ignition ON.
D The system voltage is less than 11 volts
1.5L SOHC).
DIAGNOSTIC TROUBLE CODE (DTC) P0562
SYSTEM VOLTAGE (ENGINE SIDE) TOO LOW
Action Taken When the DTC Sets
D The Malfunction Indicator Lamp (MIL) will not illumi-
nate.
D The ECM will store conditions which were pres-
ent when the DTC set as Failure Records data only.
This information will not be stored as Freeze Frame
data.
D A history DTC is stored.
Conditions for Clearing the MIL/DTC
D A history DTC will clear after 40 consecutive warm up
cycles without a fault.
D DTC(s) can be cleared by using the scan tool.
TAA1F200
DAEWOO T-154 BL2,3