Daewoo CIELO EURO III Manual page 150

DAEWOO T-154 BL2,3
11. Rotate the solenoid 90 degrees and remove it along
with the plunger return spring.
A102E247
Important: If the solenoid is not removed from the start-
ing motor, the connector strap terminals must be re-
moved from the terminal on the solenoid before making
these tests.
12. Test the solenoid windings by checking the current
draw.
12.1 Check the hold-in windings by connecting
12.2 Connect the carbon pile across the battery.
12.3 Adjust the voltage to 10 volts. The amme-
A102E221
Important: Current will decrease as the windings heat
up. Current draw readings that are over specifications
indicate shorted turns or a ground in the windings of the
solenoid. Both conditions require replacement of the so-
lenoid. Current draw readings that are under specifica-
tions indicate excessive resistance. No reading
indicates an open circuit.
13. Check both windings, connecting them according to
the preceding test.
13.1 Ground the solenoid motor terminal.
13.2 Adjust the voltage to 10 volts. The amme-
13.3 Check the connections and replace the so-
A102E221
ENGINE ELECTRICAL 1E – 22
an ammeter in series with a 12-volt battery,
the switch terminal, and to ground.
ter reading should be 13 to 19 amperes.
ter reading should be 59 to 79 amperes.
lenoid, if necessary.