Daewoo CIELO EURO III Manual page 164

DAEWOO T-154 BL2,3
3. Weld the brush holder terminal to the regulator termi-
nal, if removed.
4. Fix the brush holder with the retainer pin, and weld
the regulator/brush holder assembled terminal to the
rectifier terminal.
5. Apply silicone grease between the bridge and the end
frame for radiation purposes.
6. Fasten the screws holding the rectifier regulator/
brush holder assembly to the end frame.
7. Punch the new baffle with the pin into the brush.
A102E256
8. Install the stator.
A102E213
Notice: Take care to prevent damage to the vehicle by
protecting the diode in the rectifier bridge from exces-
sive heat while welding.
9. Weld the connectors of the rectifier bridge.
A102E202
ENGINE ELECTRICAL 1E – 36