Daewoo CIELO EURO III Manual page 85

DAEWOO T-154 BL2,3
SOHC ENGINE MECHANICAL 1B – 73
Inspection Procedure
1. Inspect the connecting rod for bending or twisting. If
the connecting rod is bent or twisted, replace the con-
necting rod.
2. Inspect the connecting rod bearings.
3. Inspect the connecting rod lower end for wear.
4. Inspect the connecting rod upper end for scoring.
5. Inspect the piston for scoring, cracks and wear.
6. Inspect the piston for taper using a micrometer.
A102B087
7. Inspect the piston for fit to the connecting rod.
A102B082
8. Inspect the engine block deck surface for flatness
using a straight edge and a feeler gauge. Refer to
"Engine Specifications" in this section.
9. Inspect the bearing bore for concentricity and align-
ment using a bore gauge. Refer to "Engine Specifi-
cations" in this section. If beyond specifications,
replace the engine block.
10. Inspect the engine block cylinder bore for wear, run-
out, ridging and taper using a bore gauge. Refer to
"Engine Specifications" in this section.
11. Inspect the engine block cylinder bore for glazing.
Lightly hone the cylinder bore as necessary.
A102B083