Crankshaft Position Sensor (Typical); Camshaft Position Sensor (Sohc) - Daewoo CIELO EURO III Manual

DAEWOO T-154 BL2,3
CRANKSHAFT POSITION SENSOR
(TYPICAL)
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the crankshaft position (CKP) sensor
connector at the frame bracket.
3. Remove the wiring tie straps as needed.
4. Remove the CKP sensor retaining bolt.
5. Remove the CKP sensor.
A102F096
Installation Procedure
1. Install the CKP sensor with the retaining bolt.
Tighten
Tighten the crankshaft position sensor retaining bolt
to 10 NSm (89 lb-in).
2. Connect the CKP sensor connector at the frame
bracket.
3. Secure the wire with the tie straps as needed.
4. Connect the negative battery cable.
A102F019
CAMSHAFT POSITION SENSOR
(SOHC)
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the sensor electrical connector.
3. Remove the camshaft position (CMP) sensor bolts
and sensor.
F41F001
ENGINE CONTROLS 1F – 405