Daewoo CIELO EURO III Manual page 101

DAEWOO T-154 BL2,3
SOHC ENGINE MECHANICAL 1B – 89
4. With the crankshaft mounted on the front and the rear
crankshaft bearings, check the middle crankshaft
journal for permissible out-of-round (runout). Refer to
''Engine Specifications'' in this section.
A102B071
5. Coat the crankshaft bearings with engine oil.
6. Apply a bead of adhesive sealing compound to the
grooves of the rear crankshaft bearing cap.
7. Install the crankshaft bearings in the engine block.
8. Install the crankshaft.
A102B069
9. Install the crankshaft bearings to the crankshaft
bearing caps.
10. Install the crankshaft bearing caps.
Notice: Do not reuse the old crankshaft bearing cap
bolts. Damage to the engine could result.
11. Install new crankshaft bearing cap bolts.
Tighten
Tighten the crankshaft bearing cap bolts to 50 N m
(37 lb-ft). Using the angular torque gauge KM-470-B,
tighten the crankshaft bearing cap bolts another 45
degrees plus 15 degrees.
12. Install the upper connecting rod bearings to the con-
necting rods.
13. Install the lower connecting rod bearings to the con-
necting rod bearing caps
A102B091