Pistons And Rods - Daewoo CIELO EURO III Manual

DAEWOO T-154 BL2,3
SOHC ENGINE MECHANICAL 1B – 71
51. Install the cooling system radiator and the engine
cooling fans. Refer to Section 1D, Engine Cooling.
52. Connect the lower radiator hose to the coolant pipe.
53. Connect the upper radiator hose to the thermostat
housing.
54. Connect the coolant surge tank hose to the radiator.
55. Connect the heater outlet hose to the coolant pipe.
56. Connect the heater inlet hose to the coolant distribu-
tor.
57. Connect the coolant surge tank hose to the coolant
pipe.
58. Connect the surge tank coolant hose to the throttle
body.
A102B017
59. Connect the throttle cable to the throttle body and
the intake manifold bracket.
60. Install the fuel pump fuse.
61. Connect the negative battery cable to the vehicle
frame.
62. Connect the negative battery cable to the battery.
63. Connect and assemble the battery positive cable.
64. Refill the engine crankcase with engine oil.
65. Refill the engine coolant system. Refer to Section
1D, Engine Cooling.
66. Bleed the power steering system as necessary. Re-
fer to Section 6A, Power Steering System.
67. Refill the A/C refrigerant system as necessary. Re-
fer to Section 7B, Manual Control Heating, Ventila-
tion, and Air Conditioning System.
68. Install the hood. Refer to Section 9R, Body Front
A102B013
End.

PISTONS AND RODS

Tools Required
KM-427 Piston Pin Service Set
KM 470-B Angular Torque Gauge
Removal Procedure
1. Remove the cylinder head with the intake manifold
and exhaust manifold attached. Refer to "Cylinder
Head and Gasket" in this section.
2. Remove the oil pan. Refer to "Oil Pan" in this sec-
tion.
3. Remove the oil pump/pickup tube bolts.
4. Remove the oil pump/pickup tube.
A102B094