Engine Coolant Temperature Sensor (Sohc) - Daewoo CIELO EURO III Manual

1F – 390 ENGINE CONTROLS
ENGINE COOLANT TEMPERATURE
SENSOR (SOHC)
Removal Procedure
1. Relieve the coolant system pressure.
2. Disconnect the negative battery cable.
3. Disconnect the engine coolant temperature (ECT)
sensor connector.
Notice: Use care when handling the ECT sensor. Dam-
age to the sensor will affect the proper operation of the
fuel injection system.
4. Carefully remove the ECT sensor from the cylinder
head underneath the electronic ignition (EI) system
ignition coil.
A102F001
Installation Procedure
1. Coat the threads on the ECT sensor with sealer.
Notice: Use care when handling the ECT sensor. Dam-
age to the sensor will affect the proper operation of the
fuel injection system.
2. Install the ECT into the cylinder head.
Tighten
Tighten the engine coolant temperature sensor to
20 NSm (15 lb-ft).
3. Connect the ECT sensor connector.
4. Fill the coolant system.
5. Connect the negative battery cable.
A102F002
DAEWOO T-154 BL2,3