Daewoo CIELO EURO III Manual page 55

DAEWOO T-154 BL2,3
SOHC ENGINE MECHANICAL 1B – 43
7. Install the oil pressure switch.
Tighten
Tighten the oil pressure switch to 40 N m (30 lb-ft).
8. Connect the electrical connector to the oil pressure
switch.
9. Install the right-hand wheel well splash shield.
10. Check the oil level and fill the oil to the FULL mark.
A102B019
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the power steering pump, if equipped. Re-
fer to Section 6A, Power Steering System.
3. Remove the timing belt. Refer to "Timing Belt" in this
section.
4. Remove the rear timing belt cover. Refer to "Rear
Timing Belt Cover" in this section.
5. Disconnect the oil pressure switch connector.
A102B019
6. Remove the crankshaft position (CKP) sensor bolt.
7. Remove the CKP sensor.
8. Remove the oil pan. Refer to "Oil Pan" in this sec-
tion.
9. Remove the oil pump pickup tube and the support
bracket bolts.
10. Remove the oil pump pickup tube.
A102B064