Surge Tank - Daewoo CIELO EURO III Manual

DAEWOO T-154 BL2,3

SURGE TANK

Removal Procedure
Caution: To prevent personal injury, do not remove
the surge tank cap while the engine and the radiator
are hot, because the heat causes the system to re-
main under pressure. Scalding fluid and steam may
be blown out under pressure.
1. Drain the engine coolant to below the level of the
surge tank.
2. Loosen the overflow hose clamps and disconnect the
overflow hoses from the surge tank.
3. Remove the tank attaching nuts.
4. Remove the tank from the vehicle.
5. Clean the inside and the outside of the surge tank and
the surge tank cap with soap and water.
6. Rinse the surge tank and the cap thoroughly.
A102D017
Installation Procedure
1. Install the surge tank to the vehicle.
2. Secure the surge tank with the attaching nuts.
Tighten
Tighten the surge tank attaching nuts to 10 N m (89
lb-in).
3. Connect the overflow hoses to the surge tank.
4. Secure the overflow hoses to the surge tank with the
hose clamps.
5. Fill the surge tank with the coolant to the center ridge,
or the MAX mark.
A102D043
ENGINE COOLING 1D – 14