Daewoo CIELO EURO III Manual page 163

1E – 35 ENGINE ELECTRICAL
20. Replace the rectifier bridge, if each reading is the
same.
21. Test the remaining two diodes after the above pro-
cedure.
Notice: Some kinds of digital ohmmeters are not suited
for the test of the bridge diode. In this case, consult the
manufacturer regarding the test capacity.
22. Test the diodes by connecting the ohmmeter termi-
nals to the bridge terminal and the base plate. If the
reading is the same, the rectifier bridge should be
replaced.
A102E211
23. Remove the ring in the slip ring end frame.
A102E212
Assembly Procedure
1. Install the new ring in the slip ring end frame.
2. Push the new bearing outer lace into the bottom of
the end frame casting.
A102E257
DAEWOO T-154 BL2,3