Daewoo CIELO EURO III Manual page 86

1B – 74 SOHC ENGINE MECHANICAL
Installation Procedure
1. Align the notch on the piston and connecting rod so
that the proper sides will be facing the front of the en-
gine.
2. Install the piston pin guide through the piston and the
connecting rod.
3. Coat the piston pin with clean oil.
4. Install the piston pin into the opposite side of the pis-
ton.
5. Install the piston pin into the piston and connecting
rod assembly using the piston pin service set
KM-427.
A102B081
6. Select a set of new piston rings.
7. Measure the piston ring gap using a feeler gauge.
Refer to "Engine Specifications" in this section.
8. Increase the piston ring gap by carefully filing off ex-
cess material if the piston ring gap is below specifi-
cations.
A102B084
9. Measure the piston ring side clearance using a feel-
er gauge. Refer to "Engine Specifications" in this
section.
10. If the piston ring is too thick, try another piston ring.
11. If no piston ring can be found that fits to specifica-
tions, the piston ring may be ground to size with
emery paper placed on a sheet of glass.
A102B085
DAEWOO T-154 BL2,3