Daewoo CIELO EURO III Manual page 32

1B – 20 SOHC ENGINE MECHANICAL
60. Gradually loosen all of the cylinder head bolts in the
sequence shown.
61. Remove the cylinder head bolts.
62. Remove the camshaft carrier assembly.
Notice: Prevent any engine oil or coolant from entering
the cylinders when removing the cylinder head. Damage
to the engine could result.
63. Remove the cylinder head with the intake manifold
and the exhaust manifold attached.
64. Remove the cylinder head gasket.
A402B006
Cleaning Procedure
1. Clean the gasket surfaces of the cylinder head and
the engine block.
2. Make sure the gasket surfaces of the cylinder head
and the engine block are free of nicks and heavy
scratches.
3. Clean the cylinder head bolts.
4. Inspect the cylinder head for warpage. Refer to "Cyl-
inder Head and Valve Train Components" in this sec-
tion.
A102B122
Installation Procedure
1. Apply a continuous 3 mm (0.12 inch) bead of gasket
maker to the sealing surface of the camshaft carrier.
2. Install the cylinder head gasket.
3. Install the cylinder head with the intake manifold and
the exhaust manifold attached.
4. Install the camshaft carrier assembly.
A402B007
DAEWOO T-154 BL2,3