Daewoo CIELO EURO III Manual page 217

Step
With a test light still connected to ground, probe the
ignition feed terminal K18.
15
Does the test light illuminate?
Repair the open battery feed circuit.
16
Is the repair complete?
Check for an open ignition feed circuit or fuse to the
MIL and repair as necessary.
17
Is the repair necessary?
Check for a poor connection in the battery feed ter-
minal K1 or the ignition feed terminal
18
K18 and repair as necessary.
Is the repair necessary?
Repair the open in the ignition feed circuit from ter-
minal K18.
19
Is the repair complete?
Replace the instrument panel cluster. Refer to Sec-
tion 9E, Instrumentation and Driver Information.
20
Is the repair complete?
Check for a faulty ECM ground connection at
the engine block or ECM connector and repair
21
as necessary.
Was the repair necessary?
1. Allow the engine to idle until normal operating
temperature is reached.
22 2. Check if any DTCs are set.
Are any DTCs displayed that have not been diag-
nosed?
DAEWOO T-154 BL2,3
No Malfunction Indicator Lamp (Cont'd)
Action
ENGINE CONTROLS 1F – 4 9
Value Yes
–
Go to Step 18
– Go to Step 22
–
Go to Step 22
–
Go to Step 22
–
Go to Step 22
–
Go to Step 22
–
Go to Step 22
–
Go to the appli-
cable DTC table
No
Go to Step 19
–
Go to Step 20
Go to Step 21
–
–
Go to Step 12
System OK