Fuel Rail And Injectors (Sohc) - Daewoo CIELO EURO III Manual

1F – 384 ENGINE CONTROLS
5. Disconnect the electrical connector at the fuel pump
assembly.
6. Disconnect the fuel outlet line.
7. Disconnect the fuel tank return line.
8. Turn the lock ring counterclockwise to clear the tank
tabs.
9. Remove the fuel pump assembly from the tank.
10. Remove and discard the gasket.
A102F025
Installation Procedure
1. Clean the gasket mating surface on the fuel tank.
2. Position the new gasket in place.
3. Install the fuel pump into the fuel tank in the same
location as removed for ease of line and connector
installation.
4. Position the lock ring in place and turn it clockwise
until it contacts the tank stop.
5. Connect the fuel pump assembly connector.
6. Install the fuel pump outlet line.
7. Install the fuel tank return line.
8. Install the pump access cover.
9. Connect the negative battery cable.
10. Perform an operational check of the fuel pump.
11. Install the rear seat. Refer to Section 9H, Seats.
A102F026

FUEL RAIL AND INJECTORS (SOHC)

Removal Procedure
Caution: The fuel system is under pressure. To
avoid fuel spillage and the risk of personal injury or
fire, it is necessary to relieve the fuel system pres-
sure before disconnecting the fuel lines.
1. Relieve the fuel pressure. Refer to "Fuel Pump" in this
section.
2. Disconnect the negative battery cable.
3. Disconnect the fuel injector harness connectors.
4. Remove the exhaust gas recirculation valve. Refer to
"Exhaust Gas Recirculation Valve (SOHC)" in this
section.
5. Remove the fuel pressure regulator. Refer to "Fuel
Pressure Regulator (SOHC)" in this section.
A402F066
DAEWOO T-154 BL2,3