Daewoo CIELO EURO III Manual page 151

1E – 23 ENGINE ELECTRICAL
14. Slide the field frame with the enclosed armature as-
sembly away from the starter assembly.
15. Remove the shield.
A102E222
16. Separate the field frame from the armature.
A102E242
17. Inspect the shaft, the bearing, and the pinion for dis-
coloration, damage, or wear. Replace, if necessary.
18. Inspect the armature commutator. If the commuta-
tor is rough, it should be turned down. The outside
diameter of the commutator must measure at least
41.91 mm (1.650 inches) after it is undercut or
turned. Do not turn out-of-round commutators.
19. Inspect the points where the armature conductors
join the commutator bars. Make sure they have a
good connection. A burned commutator bar is usu-
ally evidence of a poor connection.
20. If test equipment is available, check the armature for
short circuits by placing it on a growler, and holding
back a saw blade over the armature core while the
armature is rotated. If the saw blade vibrates, re-
place the armature.
21. Recheck the armature after cleaning between the
commutator bars. If the saw blade vibrates, replace
A102E223 the armature.
DAEWOO T-154 BL2,3