Dtc P1336 58X Crankshaft Position (Ckp) Sensor Tooth Error Not Learned - Daewoo CIELO EURO III Manual

DTC P1336 – 58X Crankshaft Position (CKP) Sensor Tooth Error Not Learned
Step
Perform an On-Board Diagnostic (EOBD) System
Check.
1
Is the check complete?
1. Install the scan tool.
2. Put the vehicle in PARK or NEUTRAL.
3. Run the engine until it is above the specified
temperature.
4. Set the vehicle parking brake and block the
wheels.
5. Turn all accessories OFF.
2
6. Enable the TEC (Tooth Error Correction) LEARN
PROCEDURE with the scan tool.
7. Raise the engine rpm to the specified value, then
release the throttle as soon as the engine cuts
out.
Does the scan tool indicate that the Crankshaft Posi-
tion (CKP) system variation has been learned?
Attempt the CKP system variation procedure as
many times as the specified value.
3
Does the scan tool indicate that the CKP system
variation has been learned?
Check for a problem with the crankshaft sensor to
crankshaft relationship.
4
Is a repair necessary?
1. Turn the ignition OFF and wait above specified
value.
2. Turn the ignition ON, with engine OFF.
3. Using the scan tool, clear the Diagnostic Trouble
Codes (DTCs).
4. Start the engine and idle at normal operating
5
temperature.
5. Operate the vehicle within the conditions for
setting this DTC as specified in the supporting
text.
Does the scan tool indicate that this diagnostic ran
and passed?
Check if any additional DTCs are set.
6
Are any DTCs displayed that have not been diag-
nosed?
DAEWOO T-154 BL2,3
Action
ENGINE CONTROLS 1F – 259
Value Yes
–
Go to Step 2
65 C (149 F)
Go to Step 5
4000 rpm
10 Go to Step 5
–
Go to Step 5
10 seconds Go to Step 6
– Go to applicable
DTC table
No
Go to "On-
Board Diag-
nostic System
Check"
Go to Step 3
Go to Step 4
–
Go to Step 2
System OK