Daewoo CIELO EURO III Manual page 78

1B – 66 SOHC ENGINE MECHANICAL
66. Remove the transaxle bell housing bolts.
67. Support the transaxle with a floor jack.
68. Install the engine lifting device.
69. Disconnect the right engine mount bracket from the
rubber engine mount by removing the two retaining
bolts.
70. Remove the right engine mount bracket from the en-
gine block.
71. Separate the engine block from the transaxle.
72. Remove the engine.
73. Transfer any necessary parts.
A102B020
Installation Procedure
1. Install the engine into the engine compartment.
2. Align the transaxle alignment pins to the transaxle.
3. Install the transaxle bell housing bolts.
Tighten
Tighten the transaxle bell housing bolts to 75 N m
(55 lb-ft).
A102B063
4. Install the right engine mount bracket to the engine
block.
5. Install the right engine mount bracket retaining bolts
to the engine block.
Tighten
Tighten the engine mount bracket retaining bolts to
60 N m (44 lb-ft).
6. Install the engine mount-to-bracket retaining bolts.
Tighten
Tighten the engine mount bracket-to-engine mount
retaining bolts to 60 N m (44 lb-ft).
7. Remove the floor jack used for support of the trans-
axle.
8. Remove the engine lifting device.
A102B020
DAEWOO T-154 BL2,3