Evaporative Emission Canister Purge Solenoid (Typical) - Daewoo CIELO EURO III Manual

1F – 404 ENGINE CONTROLS
Installation Procedure
1. Insert the EVAP emission canister into the track and
slide it into position.
2. Install the EVAP emission canister flange bolt.
Tighten
Tighten the evaporative emission canister flange bolt
to 20 NSm (15 lb-ft).
3. Connect the canister fuel vapor hoses.
A102F021
EVAPORATIVE EMISSION CANISTER
PURGE SOLENOID (TYPICAL)
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the evaporative (EVAP) emission canister
purge solenoid connector.
3. Disconnect the vacuum hoses from the EVAP emis-
sion canister purge solenoid.
4. Unclip the EVAP emission canister purge solenoid
from the mounting bracket.
A202F060
Installation Procedure
1. Attach the EVAP emission canister purge solenoid to
the mounting bracket.
2. Connect the EVAP emission canister purge solenoid
connector.
3. Connect the vacuum hoses to the EVAP emission
canister purge solenoid.
4. Connect the negative battery cable.
A202F060
DAEWOO T-154 BL2,3