Daewoo CIELO EURO III Manual page 121

DAEWOO T-154 BL2,3
Installation Procedure
Caution: If a fan blade is bent or damaged in any
way, no attempt should be made to repair or reuse
the damaged part. A bent or damaged fan assembly
must be replaced with a new fan assembly. It is es-
sential that fan assemblies remain in proper bal-
ance. A fan assembly that is not in proper balance
can fail and fly apart during use, creating extreme
danger. Proper balance cannot be assured on a fan
assembly that has been bent or damaged.
1. Install the fan motor to the shroud.
2. Secure the motor to the shroud with the retaining
screws.
Tighten
Tighten the electric cooling fan (main) motor retaining
screws to 4 N m (35 lb-in).
A102D007
3. Install the fan to the motor with the single nut in the
center of the fan hub.
Tighten
Tighten the electric cooling fan (main) motor nut to
3.2 N m (28 lb-in).
A102D006
4. Install the electric cooling fan shroud assembly to the
radiator.
Important: Be careful to seat the mounting post on the
fan shroud into the socket at the radiator left tank. Be
sure to slip the tab at the bottom edge of the shroud into
the retaining clip near the center of the radiator.
5. Secure the shroud to the top of the radiator with the
mounting bolts.
Tighten
Tighten the electric cooling fan assembly (main)
mounting bolts to 4 N m (35 lb-in).
6. Install the electrical connector to the cooling fan.
7. Connect the negative battery cable.
B102D010
ENGINE COOLING 1D – 13