Dtc P0336 58X Crankshaft Position (Ckp) Sensor Extra/Missing Pulses - Daewoo CIELO EURO III Manual

cords data on the scan tool if applicable. This
creates an electronic copy of the data taken when
the malfunction occurred. The information is then
stored on the scan tool for later reference.

DTC P0336 58X Crankshaft Position (CKP) Sensor Extra/Missing Pulses

Step
Perform an On-Board Diagnostic (EOBD) System
Check.
1
Is the system check complete?
Attempt to start the engine.
Does the engine start?
2
1. Review and record Failure Records information.
2. Clear DTC P0336.
3 3. Start the engine and idle for 1 minute.
4. Observe the Diagnostic Trouble Codes (DTCs).
Is DTC P0336 set?
1. Disconnect the
engine control module (ECM) and the
Crankshaft Position (CKP) sensor.
2. Check for an open or a short to ground in the 58X
4
high circuit between the CKP sensor connector
and the ECM harness connector.
Is a problem found?
Repair the open or short to ground in the 58X high
circuit between the CKP sensor connector and the
5
ECM harness connector.
Is the repair complete?
1. Reconnect the ECM and CKP sensor.
2. Connect a digital voltmeter (DVM) to measure
voltage on the 58X high circuit, terminal
M21 at the ECM connector.
6
3. Observe the voltage while cranking the engine.
Does the voltage fluctuate between the specified
value?
Check the connections at the CKP sensor and re-
place the terminals if necessary.
7
Do any terminals require replacement?
1. Turn the ignition switch OFF.
8 2. Replace the CKP sensor.
Is the action complete?
Check the connections at the ECM and re-
place the terminals if necessary.
9
Do any terminals require replacement?
1. Turn the ignition switch OFF.
10 2. Replace the ECM.
Is the action complete?
DAEWOO T-154 BL2,3
Action
ENGINE CONTROLS 1F – 255
10. The replacement ECM must be repro-
grammed. Refer to the latest Techline procedure for
ECM reprogramming.
Value
–
Go to Step 2
–
Go to Step 3
–
Go to Step 4
–
Go to Step 5
–
Go to Step 11
2.4 – 2.7 v Go to Step 9
–
Go to Step 11
–
Go to Step 11
–
Go to Step 11
–
Go to Step 11
Yes No
Go to
"On-Board
Diagnostic
System Check"
Refer to "En-
gine Cranks
But Will Not
Run"
Refer to "Diag-
nostic Aids"
Go to Step 6
–
Go to Step 7
Go to Step 8
–
Go to Step 10
–