Network Time Protocol Commands - Alcatel-Lucent 7210 SAS M Configuration Manual

Date and Time Commands

Network Time Protocol Commands

ntp
Syntax [no] ntp
Context config>system>time
Description
This command enables the context to configure Network Time Protocol (NTP) and its operation. This
protocol defines a method to accurately distribute and maintain time for network elements.
Furthermore this capability allows for the synchronization of clocks between the various network
elements. Use the no form of the command to stop the execution of NTP and remove its
configuration.
Default
none
authentication-check
Syntax [no] authentication-check
Context config>system>time>ntp
Description This command provides the option to skip the rejection of NTP PDUs that do not match the
authentication key-id, type or key requirements. The default behavior when authentication is
configured is to reject all NTP protocol PDUs that have a mismatch in either the authentication key-
id, type or key.
When authentication-check is enabled, NTP PDUs are authenticated on receipt. However,
mismatches cause a counter to be increased, one counter for type and one for key-id, one for type,
value mismatches. These counters are visible in a show command.
The no form of this command allows authentication mismatches to be accepted; the counters however
are maintained.
Default
authentication-check — Rejects authentication mismatches.
authentication-key
Syntax authentication-key key-id {key key} [hash | hash2] type {des | message-digest}
no authentication-key key-id
Context config>system>time>ntp
Description This command sets the authentication key-id, type and key used to authenticate NTP PDUs sent to or
received by other network elements participating in the NTP protocol. For authentication to work, the
authentication key-id, type and key value must match.
The no form of the command removes the authentication key.
Page 358
Guide
7210 SAS M, T, X, R6 Basic System Configuration