Alcatel-Lucent 7210 SAS M Configuration Manual page 495

Sample Output
*A:7210-SAS>show>system# sync-if-timing
===============================================================================
System Interface Timing Operational Info
===============================================================================
System Status CPM A
Reference Order
Reference Input 1
7210 SAS M, T, X, R6 Basic System Configuration Guide
Label
Selected For Use
Source Port
Reference Input 2
Admin Status
Qualified For Use
Selected For Use
Not Selected Due To
Source Port
Quality Level Selec-
tion
System Quality Level
Rx Quality Level
Reference Input Mode
Quality Level Selection
System Quality Level
Admin Status
Rx Quality Level
Description (Continued)
Indicates if reference input 1 is selected for use
Displays the source port information
Displays information about reference input 2
Indicates the Admin status of reference input 2.
down — Indicates the ref1 or ref2 configuration is administratively
shutdown.
up — Indicates the ref1 or ref2 configuration is administratively
enabled.
diag — Indicates the reference has been forced using the force-refer-
ence command.
Indicates if the reference input 2 is qualified for use.
Indicates if reference input 2 is selected for use
Indicates the reason if reference input 2 is not selected.
Displays the source port information
Indicates whether the ql-selection command has been enabled or dis-
abled. If this command is enabled, then the reference is selected first
using the QL value, then by the priority reference order. If this com-
mand is not enabled, then the reference is selected by the priority refer-
ence order.
Indicates the quality level being generated by the system clock.
Indicates the QL value received on the interface.
• inv - SSM received on the interface indicates an invalid code for
the interface type.
• unknown - No QL value was received on the interface.
: Master Locked
: Non-revertive
: Enabled
: prc
: ref1 ref2
: up
: prc
System Management
Page 495