Alcatel-Lucent 7210 SAS M Configuration Manual page 332

System Information Commands
Syntax coordinates coordinates
no coordinates
Context config>system
Description
This command creates a text string that identifies the system coordinates for the device location. For
example, the command coordinates "37.390 -122.0550" is read as latitude 37.390 north and
longitude 122.0550 west.
Only one set of coordinates can be configured. If multiple coordinates are configured, the last one
entered overwrites the previous entry.
The no form of the command reverts to the default value.
Default
none — No coordinates are configured.
Parameters
coordinates — The coordinates describing the device location character string. The string may be up
lacp-system-priority
Syntax lacp-system-priority lacp-system-priority
no lacp-system-priority
Context config>system
Description This command configures the Link Aggregation Control Protocol (LACP) system priority on
aggregated Ethernet interfaces. LACP allows the operator to aggregate multiple physical interfaces to
form one logical interface.
Default
32768
Parameters lacp-system-priority — Specifies the LACP system priority.
location
Syntax location location
no location
Context config>system
Description
This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered
overwrites the previous entry.
The no form of the command reverts to the default value.
Page 332
Guide
to 80 characters long. Any printable, seven-bit ASCII characters can be used within the string. If
the string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes. If the coordinates are subsequently used by an algorithm that locates the exact
position of this node then the string must match the requirements of the algorithm.
Values
1 — 65535
7210 SAS M, T, X, R6 Basic System Configuration