Alcatel-Lucent 7210 SAS M Configuration Manual page 460

System Commands
Page 460
Label
Excess
Outlyer
Candidate
Selected
Chosen
ChosenPPS
Remote
Reference ID
7210 SAS M, T, X, R6 Basic System Configuration Guide
Description (Continued)
The peer's synchronization distance is greater than ten other peers.
This peer will not be used for synchronization.
The peer is discarded as an outlyer. This peer will not be used for syn-
chronization.
The peer is accepted as a possible source of synchronization.
The peer is an acceptable source of synchronization, but its synchroni-
zation distance is greater than six other peers.
The peer is chosen as the source of synchronization.
The peer is chosen as the source of synchronization, but the actual syn-
chronization is occurring from a pulse-per-second (PPS) signal.
The IP address of the remote NTP server or peer with which this local
host is exchanging NTP packets.
When stratum is between 0 and 15 this field shows the IP address of
the remote NTP server or peer with which the remote is exchanging
NTP packets. For reference clocks, this field shows the identification
assigned to the clock, such as, ".GPS." For an NTP server or peer, if
the client has not yet synchronized to a server/peer, the status cannot be
determined and displays the following codes:
Peer Codes:
ACST — The association belongs to any cast server.
AUTH — Server authentication failed. Please wait while the associa-
tion is restarted.
AUTO — Autokey sequence failed. Please wait while the association
is restarted.
BCST — The association belongs to a broadcast server.
CRPT — Cryptographic authentication or identification failed. The
details should be in the system log file or the cryptostats statistics file,
if configured. No further messages will be sent to the server.
DENY — Access denied by remote server. No further messages will
be sent to the server.