Alcatel-Lucent 7210 SAS M Configuration Manual page 438

System Resource-Profile Commands
With the no form of the command, the software does not allocate any resources for use by SAP
ingress aggregate meter. If no resources are allocated for use, then the software fails all attempts to
associate an aggregate-meter with SAP ingress.
Parameters
num-resources — Specifies the maximum amount of resources for use by this filter match criteria.
max-ipv6-routes
Syntax [no] max-ipv6-routes number
Context configure>system>resource-profile>
Description
This command allows the user to allocate IPv6 route entries in the L3 forwarding table.
L3 forwarding table entries is shared among IPv4 and IPv6 route entries. Before adding routes for
IPv6 destinations, route entries in the routed lookup table needs to be allocated for IPv6 addresses
using this command. This command allocates route entries for /64 IPv6 prefix route lookups. The
remainder of the L3 forwarding table is used for IPv4 routing entries. The system does not allocate
any IPv6 route entries by default and user needs to allocate some resources before using IPv6.
NOTES:
With the no form of the command, the software does not allocate any resources for use by IPv6
routes.
Default no max-ipv6-routes
Parameters
number — Specifies the maximum amount of entries to be used for IPv6 routes.
Page 438
Guide
Platforms
7210 SAS-M (per node)
7210 SAS-X (per node)
7210 SAS-T Access-uplink
mode (per node)
7210 SAS-R6 (per IMM)
• For the command to take effect the node must be rebooted after making the change. Please see
the example below and the Basic systems user guide for more information.
• A separate route table is used for IPv6 /128-bit prefix route lookup. A limited amount of IPv6 /
128 prefixes route lookup entries is supported. The software enables lookups in this table by
default (in other words no user configuration is required to enable IPv6 /128-bit route lookup).
• IPv6 IP interfaces are allowed to be created without allocating IPv6 route entries. With this only
IPv6 hosts on the same IPv6 subnet will be reachable.
Values Please see the table below.
7210 SAS M, T, X, R6 Basic System Configuration
Min value Max value
(per node) (per node)
0 1
0 2
0 2
0 2
Default
Values
-
2
2