Alcatel-Lucent 7210 SAS M Configuration Manual page 150

Common Configuration Tasks
eth-mgmt port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings: edit
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted decimal form with a network length.
example:
The existing eth-mgmt Active IP address is 10.135.25.53/24. Press ENTER to keep it.
Enter eth-mgmt Active IP Address : 10.135.25.53/24
In case of an IPv6, the IPv6 address should be
entered in standard colon hexadecimal notation
with a prefix length.
Enter eth-mgmt Active IPv6 Address (Type 0 if none desired): 0
The existing eth-mgmt Standby IP address is 10.135.25.54/24. Press ENTER to keep it.
Enter eth-mgmt Standby IP Address : 10.135.25.54/24
In case of an IPv6, the IPv6 address should be
entered in standard colon hexadecimal notation
with a prefix length.
Enter eth-mgmt Standby IPv6 Address (Type 0 if none desired): 0
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example:
A static route to the Primary Image exists: 135.0.0.0/8 next-hop 10.135.25.1
Do you want to keep it? (yes/no) y
Would you like to add a static route? (yes/no) yes
Enter ip route: 10.135.0.0/16 next-hop 10.135.25.1
A route to that subnet already exists.
Would you like to add a static route? (yes/no) n
Would you like to add a static IPv6 route? (yes/no) n
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting
New Settings
------------
primary-image
secondary-image
tertiary-image
primary-config
secondary-config
Page 150
192.168.1.169/24
example: 3FFE::1/112
example: 3FFE::1/112
192.168.0.0/16 next-hop 192.168.1.254
ftp://*:*@135.250.26.204/tmp/sasr/b/
cf1:\
uf1:\
uf1:\SASR2553.cfg
uf1:\SASR2553.cfg
7210 SAS M, T, X, R6 Basic System Configuration Guide
or 'disable' to disable console access: