Alcatel-Lucent 7210 SAS M Configuration Manual page 135

eth-mgmt-speed
#uplinkA Port Settings:
uplinkA-port
uplinkA-address
uplinkA-vlan
#uplinkB Port Settings:
uplinkB-port
uplinkB-address
uplinkB-vlan
#System Settings:
wait
persist
console-speed
uplink-mode
acl-mode
use-expansion-card-type
no
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Password:
Incorrect password
Password:
Incorrect password
Password:
Incorrect password
Authentication failed, Do you want to reset password?(yes/no)
*******************************************************************
On reset,the node's flash contents will be set to factory defaults.
All files on the flash will be removed. If present, files
cf1:/boot.tim and cf1:/both.tim are not removed.
Please ensure that you have a backup of the required
files before you proceed.
*******************************************************************
'yes' or 'no' ?
'yes' or 'no' ? yes
********************************************
*** Chassis must not be powered off nor
*** cards removed while password reset
*** is in progress
********************************************
Password reset complete. Restarting...
At this point the password has been reset and the node is rebooted to boot up with factory default
settings.
Resetting...OK
ø
7210 SAS M, T, X, R6 Basic System Configuration Guide
100
1/1/1
0
0
1/1/2
0
0
3
off
115200
network
IPv6-None
console-disabled
m4-ds1-ces
***
***
***
Boot Option Files
Page 135