Alcatel-Lucent 7210 SAS M Configuration Manual page 394

System Administration Commands
A:ALA-1>admin# save ftp://test:test@192.168.x.xx/./100.cfg
Saving configuration .........Completed.
By default, the running configuration is saved to the primary configuration file.
Parameters
file-url — The file URL location to save the configuration file.
detail — Saves both default and non-default configuration parameters.
index — Forces a save of the persistent index file regardless of the persistent status in the BOF file.
enable-tech
Syntax [no] enable-tech
Context admin
Description
This command enables the shell and kernel commands.
NOTE: This command should only be used with authorized direction from the Alcatel-Lucent
Technical Assistance Center (TAC).
tech-support
Syntax tech-support file-url
Context admin
Description
This command creates a system core dump.
NOTE: This command should only be used with authorized direction from the Alcatel-Lucent
Technical Assistance Center (TAC).
Page 394
Guide
Default The primary configuration file location.
Values
<file-url>
cflash-id
usb-flash-id
The index option can also be used to avoid an additional boot required while changing your
system to use the persistence indices.
7210 SAS M, T, X, R6 Basic System Configuration
: <local-url>|<remote-url> - [255 chars max]
local-url - [<cflash-id>/ | <usb-flash-id>][file-path]
remote-url - [{ftp://|tftp://}<login>:<pswd>@
<remote-locn>/][<file-path>]
remote-locn - [ <hostname> | <ipv4-address> |
"["<ipv6-address>"]" ]
ipv4-address a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface - 32 chars max, for link
local addresses
- cf1:, cf2 (only on 7210 SAS-T)
-uf1: