Alcatel-Lucent 7210 SAS M Configuration Manual page 436

System Resource-Profile Commands
With the no form of the command, software does not allocate any resources for use by SAP ingress
QoS policies.
If no resources are allocated for use, then the software fails all attempts to associate a service entity
(For example: SAP, IP interface, and other service entities.) with a SAP ingress QoS policy using any
of the match criteria.
Parameters
num-resources — Specifies the amount of resources that can be allocated for use by SAP ingress QoS
policies.
The following are the min, max and default values:
sap-aggregate-meter
Syntax [no] sap-aggregate-meter num-resource
Context configure>system>resource-profile>ingress-internal-tcam>
Description NOTE: This command is not supported on 7210 SAS-E.
This command allows the user to allocate maximum resources for use by meters/policers used to
implement SAP ingress aggregate meter functionality from the global pool of ingress CAM
resources. Before using the command configure> service> sap> ingress> aggregate-meter-rate user
must ensure that resources are allocated to aggregate meters using this command.
NOTE: For the command to take effect the node must be rebooted after making the change.
This command allocates meter resources from the available global ingress CAM resource pool. By
default, when resources are allocated to SAP ingress QoS policy, along with the CAM classification
entries, meter resources are also allocated. Hence, if user needs to use SAP aggregate meter
functionality they cannot allocate all the available resources in the global resource pool to SAP
Page 436
Guide
Platforms Min value
(per node)
7210 SAS-M 0
(per node)
7210 SAS-X 0
(per node)
7210 SAS-T 0
Access-uplink
mode (per node)
7210 SAS-T 0
Network Mode
(per node)
7210 SAS-R6 0
(per IMM)
7210 SAS M, T, X, R6 Basic System Configuration
Max value Default
(per node) Values
10 5
8 6
7 4
6 max
5 3