Alcatel-Lucent 7210 SAS M Configuration Manual page 393

reboot
Syntax reboot [upgrade] [auto-init] [now]
Context admin
Description
This command is used only to reboot the system or initiate an upgrade of the firmware along with a
reboot of the node or initiate an auto-init boot procedure along with a reboot of the node.
If no options are specified, the user is prompted to confirm the reboot operation. For example:
ALA-1>admin# reboot
Are you sure you want to reboot (y/n)?
If the now option is specified, boot confirmation messages appear.
Note : The upgrade option is supported only on 7210 SAS-M devices.
Parameters
upgrade — Enables card firmware (CPLD and ROM) to be upgraded during chassis reboot. The
now — Forces a reboot of the router immediately without an interactive confirmation.
auto-init — Specifies to reset the BOF and initiates a reboot.
save
Syntax save [file-url] [detail] [index]
Context admin
Description This command saves the running configuration to a configuration file. For example:
7210 SAS M, T, X, R6 Basic System Configuration Guide
7210 SAS OS and the boot.tim support functionality to perform automatic firmware upgrades.
The automatic upgrade must be enabled in the 7210 SAS OS Command Line Interface (CLI)
when rebooting the system.
When the upgrade keyword is specified, a chassis flag is set for the BOOT Loader (boot.tim)
and on the subsequent boot of the 7210 SAS OS on the chassis, any firmware images requiring
upgrading will be upgraded automatically.
If an 7210 SAS is rebooted with the admin reboot command (without the upgrade keyword),
the firmware images are left intact.
During any firmware upgrade, automatic or manual, it is imperative that during the upgrade
procedure:
• Power must NOT be switched off or interrupted.
• The system must NOT be reset.
• No cards are inserted or removed.
Any of the above conditions may render cards inoperable requiring a return of the card for
resolution.
System Management
Page 393