Alcatel-Lucent 7210 SAS M Configuration Manual page 80

Monitor CLI Commands
Parameters lag-id — The number of the LAG.
interval seconds — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
Sample Output
A:ALA-12# monitor lag 2
===============================================================================
Monitor statistics for LAG ID 2
===============================================================================
Port-id
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
1/1/1
1/1/2
1/1/3
-------------------------------------------------------------------------------
Totals
-------------------------------------------------------------------------------
At time t = 5 sec (Mode: Delta)
-------------------------------------------------------------------------------
1/1/1
1/1/2
1/1/3
-------------------------------------------------------------------------------
Totals
===============================================================================
A:ALA-12#
Page 80
Default
none — The LAG ID value must be specified.
Values
1 — 12
Default 5 seconds
Values
3 — 60
Default 10
Values 1 — 999
processing. No calculations are performed on the delta or rate statistics.
of the delta.
Input Input
Bytes Packets Bytes
2168900 26450
10677318 125610
2168490 26445
15014708 178505
0 0
258 3
82 1
340 4
7210 SAS M, T, X, R6 Basic System Configuration Guide
Output Output Input
Packets Errors
64 1 0
2273750 26439 0
0 0 0
2273814 26440 0
0 0 0
86 1 0
0 0 0
86 1 0
Output
Errors
0
0
0
0
0
0
0
0