Alcatel-Lucent 7210 SAS M Configuration Manual page 162

Service Management Tasks
Resetting...OK
Alcatel-Lucent 7210 Boot ROM. Copyright 2000-2009 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Running POST tests from ROM
Testing ROM load area...done
Relocating code...Jumping to RAM
...
When an admin reboot auto-init command is issued, the system resets the existing BOF file and
reboots. The system startup process after the admin reboot auto-init command is executed is the
same as the first time system boot as described in System Intialization on page 118.
NOTE: Since the BOF is reset, the system may not boot up withthe last saved system
configuration unless the new BOF file also uses the same configuration file. If it is required that
the system boot up with the last saved system configuration, it is recommended to use the
admin>save file-url command to save the current system configuration and modify the BOF to
use this.
Use the following CLI to reset the BOF and reboot:
CLI Syntax: admin# reboot auto-init [now]
Example: *A:ALA-1# admin reboot auto-init
WARNING: Configuration and/or Boot options may have changed since the last save.
Are you sure you want to reset the bof and reboot (y/n)? Y
Resetting...OK
Alcatel-Lucent 7210 Boot ROM. Copyright 2000-2008 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Page 162 7210 SAS M, T, X, R6 Basic System Configuration Guide