Alcatel-Lucent 7210 SAS M Configuration Manual page 337

Parameters
card-id — The card ID used to identify the card on the 1830 VWM clip-on device attached to 7210
SAS. Card ID 1 identifies the module in slot #1 of the 1830 CWDM device and Card ID 2 identifies
the module in slot #2 of the 1830 CWDM device.
shutdown
Syntax [no] shutdown
Context config> system> vwm-shelf <vwm-shelf-id>
Description
This CLI command allows the user to administratively disable the management of the clip-on device
identified by the parameter vwm-shelf-id. When this command is executed, 7210 software will clear
all pending events/traps/alarms related to this shelf.
The no form of the command allows the user to administratively enable the management of the clip-
on device. The software raises appropriate events/traps/alarms for the device.
Default no shutdown
card-type
Syntax [no] card-type card-type
Context config>system>vwm-shelf>card
Description
This command provides the user a better control over the modules plugged into the 1830 CWDM
device slots. The user can pre-provision acceptable modules by configuring the card-type parameter
with the appropriate card-type vwm-acronym. The modules are identified using the acronyms listed
below.
The 7210 SAS validates the configured card-types with the card-type acronym retrieved from the
clip-on device and checks the following:
If the user has pre-provisioned the card set to administratively up and the module is missing, 7210
SAS raises an event/trap. The event results in a major alarm with the major LED set to the appropriate
color. If the user has pre-provisioned the card and administratively shut it down, 7210 SAS does not
attempt to match the module's identifier (if the module is equipped in the slot) and clear any pending
7210 SAS M, T, X, R6 Basic System Configuration Guide
Values
[1 | 2]
• If the configured card-type matches the card-type acronym retrieved from the clip-on device,
7210 SAS allows management of the module.
• If the configured card-type does not match the card-type acronym retrieved from the clip-on
device, 7210 SAS raises an event to alert the user of mismatch in configuration. The event results
in a major alarm with the major LED set. In such a case, the card status displays "Equipment Mis-
match" error.
• The mismatch event/trap is cleared if the module is replaced with the one that has a correct card-
type acronym. Any pending trap/event, major alarm and major LED is cleared.
System Management
Page 337