Alcatel-Lucent 7210 SAS M Configuration Manual page 471

Syntax thresholds
Context show>system
Description
This command display system monitoring thresholds.
Output Thresholds Output — following table describes system threshold output fields.
7210 SAS M, T, X, R6 Basic System Configuration Guide
Label
Variable
Alarm Id
Last Value
Rising Event Id
Threshold
Falling Event Id
Threshold
Sample Interval
Sample Type
Startup Alarm
Owner
Description
Event Id
Last Sent
Action Type
Owner
Displays the variable OID.
Displays the numerical identifier for the alarm.
Displays the last threshold value.
Displays the identifier of the RMON rising event.
Displays the identifier of the RMON rising threshold.
Displays the identifier of the RMON falling event.
Displays the identifier of the RMON falling threshold.
Displays the polling interval, in seconds, over which the data is
sampled and compared with the rising and falling thresholds.
Displays the method of sampling the selected variable and calculating
the value to be compared against the thresholds.
Displays the alarm that may be sent when this alarm is first created.
Displays the owner of this alarm.
Displays the event cause.
Displays the identifier of the threshold event.
Displays the date and time the alarm was sent.
log — An entry is made in the RMON-MIB log table for each event
occurrence. This does not create a TiMOS logger entry. The RMON-
MIB log table entries can be viewed using the show>system>thresh-
olds CLI command.
trap — A TiMOS logger event is generated. The TiMOS logger utility
then distributes the notification of this event to its configured log desti-
nations which may be CONSOLE, telnet session, memory log, cflash
file, syslog, or SNMP trap destinations logs.
both — Both a entry in the RMON-MIB logTable and a TiMOS logger
event are generated.
none — No action is taken
Displays the owner of the event.
System Management
Description
Page 471