Alcatel-Lucent 7210 SAS M Configuration Manual page 334

System Information Commands
Syntax oper-group name [create]
no oper-group
Context config>system
Description
This command creates a system-wide group name which can be used to associate a number of service
objects (for example, ports). The status of the group is derived from the status of its members. The
status of the group can then be used to influence the status of non-member objects. For example,
when a group status is marked as down, the object(s) that monitor the group change their status
accordingly.
The no form of the command removes the group. All the object associations need to be removed
before the no command can be executed.
Default
no oper-group
Parameters name — Specifies the operational group identifier up to 32 characters in length.
create — This keyword is required when first creating the configuration context. Once the context is
hold-time
Syntax hold-time
Context config>system>oper-group
Description This command enables the context to configure hold time information.
group-down
Syntax [no] group-down time in seconds
Context config>system>oper-group>hold-time
Description
This command configures the number of seconds to wait before notifying clients monitoring this
group when its operational status transitions from down to up. A value of zero indicates that
transitions are reported immediately to monitoring clients.
The no form sets the values back to the defaults.
Default 0
Parameters
time in seconds —
Page 334
Guide
Values [32 chars max]
created, it is possible to navigate into the context without the create keyword.
Values
Keyword
Values
[0..3600]
7210 SAS M, T, X, R6 Basic System Configuration