Alcatel-Lucent 7210 SAS M Configuration Manual page 293

System Management
Show Command Output and Console Messages
The command displays the current value of the bad/good exec
show>system>information
URLs and indicates whether a post-boot configuration extension file was executed when the
system was booted. If an extension file was executed, the
show>system>information
command also indicates if it completed successfully or not.
When executing a post-boot configuration extension file, status messages are output to the
CONSOLE screen prior to the "Login" prompt.
Following is an example of a failed boot-up configuration that caused a boot-bad-exec file
containing another error to be executed:
Attempting to exec configuration file:
'ftp://test:test@192.168.xx.xxx/./12.cfg' ...
System Configuration
Log Configuration
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File ftp://test:test@192.168.xx.xxx/./12.cfg, Line 195: Command "log" failed.
CRITICAL: CLI #1002 An error occurred while processing the configuration file.
The system configuration is missing or incomplete.
MAJOR: CLI #1008 The SNMP daemon is disabled.
If desired, enable SNMP with the 'config>system>snmp no shutdown' command.
Attempting to exec configuration failure extension file:
'ftp://test:test@192.168.xx.xxx/./fail.cfg' ...
Config fail extension
Enabling SNMP daemon
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File ftp://test:test@192.168.xx.xxx/./fail.cfg, Line 5: Command "abc log" failed.
TiMOS-B-x.0.Rx both/hops ALCATEL Copyright (c) 2000-20011 Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Thu Nov 207 19:19:11 PST 2008 by builder in /rel5x.0/b1/Rx/panos/main
Login:
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 293