Alcatel-Lucent 7210 SAS M Configuration Manual page 175

________________________________________________________________________________
Default none
Parameters
ip-address — Specifies an IPv4 ip-address in the form a.b.c.d, for example, 10.1.2.10.
uplinkA-address
Syntax uplinkA-address ip-address/mask
no uplinkA-address
Context bof
Description This command configures the uplink-A address.
The no form of the command sets the uplinkA to use DHCP to get the IP and the show bof value
reflects 0 for this parameter.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
________________________________________________________________________________
Parameters
ip-address — The IP address of the Boot Option File (BOF). This address must be unique within the
mask — The subnet mask length when the IP prefix is specified in CIDR notation. When the IP prefix
uplinkB-address
Syntax uplinkB-address ip-address/mask
no uplinkB-address
Context bof
Description
This command configures the uplink-B address.
The no form of the command sets the uplinkB to use DHCP to get the IP and the show bof value
reflects 0 for this parameter.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
________________________________________________________________________________
7210 SAS M, T, X, R6 Basic System Configuration Guide
subnet and specified in dotted decimal notation.
is specified in CIDR notation, a forward slash (/) separates the ip-addr from the mask-length
parameter. The mask length parameter indicates the number of bits used for the network portion
of the IP address; the remainder of the IP address is used to determine the host portion of the IP
address.
Values
1 — 30
Boot Option Files
Page 175