Alcatel-Lucent 7210 SAS M Configuration Manual page 355

Default
sdh
Parameters sdh — Specifies the values used on a G.781 Option 1 compliant network.
sonet — Specifies the values used on a G.781 Option 2 compliant network.
peer
Syntax peer ip-address
Context config>system>ptp
This command configures a remote PTP peer. It provides the context to configure parameters for the
remote PTP peer.
Up to twenty remote PTP peers may be configured.
The no form of the command deletes the specified peer.
If the clock-type is ordinary slave or boundary, and PTP is no shutdown, the last peer cannot be
deleted. This prevents the user from having PTP enabled without any peer configured & enabled.
Peers cannot be created when the clock-type is ordinary master.
Default
none
Parameters
ip-address — The IP address of the remote peer.
priority
Syntax priority local_priority
Context configure>system>ptp>peer>
This command configures the local priority used to choose between PTP masters in the best master
clock algorithm (BMCA). This setting is only relevant when the g.8265.1-2010 profile is selected.
The parameter is ignored when the ieee1588-2008 profile is selected. The value 1 is the highest
priority and 255 is the lowest priority.
The priority of a peer cannot be configured if the PTP profile is ieee1588-2008.
There is a limit of 20 configured PTP peers.
Default
128
Parameters local_priority — Specifies the value of the local priority.
shutdown
7210 SAS M, T, X, R6 Basic System Configuration Guide
Values
ipv4-address a.b.c.d
Values
1-255
System Management
Page 355