Alcatel-Lucent 7210 SAS M Configuration Manual page 410

Rollback Commands
Peer Commands
peer
Syntax [no] peer ip-address
Context config>redundancy>multi-chassis
Description
Platforms Supported: 7210 SAS-R6.
This command configures a multi-chassis redundancy peer.
Parameters ip-address — Specifies a peer IP address. Multicast address are not allowed.
authentication-key
Syntax authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
config>redundancy>multi-chassis>peer
Context
Description
Platforms Supported: 7210 SAS-R6.
This command configures the authentication key used between this node and the multi-chassis peer.
The authentication key can be any combination of letters or numbers.
Parameters
authentication-key — Specifies the authentication key. Allowed values are any string up to 20
hash-key — The hash key. The key can be any combination of ASCII characters up to 33 (hash1-key)
hash — Specifies the key is entered in an encrypted form. If the hash or hash2 parameter is not used,
hash2 — Specifies the key is entered in a more complex encrypted form that involves more
Page 410
Guide
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
or 55 (hash2-key) characters in length (encrypted). If spaces are used in the string, enclose the
entire string in quotation marks (" ").
the key is assumed to be in a non-encrypted, clear text form. For security, all keys are stored in
encrypted form in the configuration file with the hash or hash2 parameter specified.
variables then the key value alone, this means that hash2 encrypted variable cannot be copied and
pasted. If the hash or hash2 parameter is not used, the key is assumed to be in a non-encrypted,
clear text form. For security, all keys are stored in encrypted form in the configuration file with
the hash or hash2 parameter specified.
7210 SAS M, T, X, R6 Basic System Configuration