Alcatel-Lucent 7210 SAS M Configuration Manual page 459

Available Memory
===============================================================================
A:ALA-1#
ntp
Syntax ntp [{peers | peer peer-address} | {servers | server server-address} |[all]] [detail]
Context show>system
Description This command displays NTP protocol configuration and state.
Output Show NTP Output — The following table describes NTP output fields.
7210 SAS M, T, X, R6 Basic System Configuration Guide
:
Label
Enabled
Admin Status
NTP Server
Stratum
Oper Status
Auth Check
System Ref. ID
Auth Error
Auth Errors
Ignored
Auth key ID Errors
Auth Key Type
Errors
Reject
Invalid
640,178,652 bytes
— NTP is enabled.
yes
no — NTP is disabled.
— Administrative state is enabled.
yes
— Administrative state is disabled.
no
Displays NTP server state of this node.
Displays stratum level of this node.
— The operational state is enabled.
yes
— The operational state is disabled.
no
Displays the authentication requirement
IP address of this node or a 4-character ASCII code showing the state.
Displays the number of authentication errors.
Displays the number of authentication errors ignored.
Displays the number of key identification errors .
Displays the number of authentication key type errors.
The peer is rejected and will not be used for synchronization. Rejection
reasons could be the peer is unreachable, the peer is synchronized to
this local server so synchronizing with it would create a sync loop, or
the synchronization distance is too large. This is the normal startup
state.
The peer is not maintaining an accurate clock. This peer will not be
used for synchronization.
System Management
Description
Page 459