Alcatel-Lucent 7210 SAS M Configuration Manual page 336

System Information Commands
vwm-shelf
Syntax [no] vwm-shelf vwm-shelf-id [create]
Context config>system
Description Provides the context to configure the shelf information for 1830 VWM clip-on device.
The user must create the VWM clip-on device and provision the shelf ID to allow the 7210 software
to communicate with the shelf and retrieve information. The value specified in the parameter vwm-
shelf-id must match the shelf ID set using the rotary dial on the clip-on device. If these shelf IDs do
not match, 7210 SAS devices will not be able to interact to the device and does not provide any
information about the device. 7210 software cannot detect a mismatch between the value of the
configured vwm-shelf-id and the shelf ID set on the rotary dial.
In prior releases, the software allows user to configure only a single clip-on device for management
by specifying a single shelf ID. The software does not allow for configuration of more than a single
clip-on shelf.
A fixed number of 1830 VWM devices can be managed by the 7210 SAS devices. The limit depends
on the interface used to connect to the 1830 device. User must provision all the shelves that are
connected to the 7210 SAS device.
The no form of the command removes the configured shelf ID and the software removes all the
information it has for the shelf.
Default
No default value is used.
Parameters vwm-shelf-id — The Shelf ID used to identify the 1830 VWM clip-on device attached to 7210.
NOTE: The vwm-shelf-id can take values in the range 1 to 7. This implies that the rotary switch on
the connected optical clip-on device must be set to a value in this range.
create — Keyword used to create the vwm-shelf-id.
card
Syntax card card-id
Context config>system>vwm-shelf
Description This command provides the context to provision the information for the modules that can be plugged
into the slots on the 1830 VWM clip-on device.
This command provides the user for a better control over the modules plugged into the 1830 CWDM
device slots. User can pre-provision acceptable modules by configuring the card-type parameter with
the appropriate vwm-acronym. Modules are identified using the card type acronyms listed below.
The no form of the command removes the configured card ID and the software forgets all the
information it has for the card. Software will not raise any events/traps/alarms for the card and clear
all pending events/traps/alarms/LEDs.
Default No default
Page 336
Guide
Values 1-7
7210 SAS M, T, X, R6 Basic System Configuration