Alcatel-Lucent 7210 SAS M Configuration Manual page 70

Global Commands
traceroute
Syntax traceroute {ip-address | dns-name} [ttl ttl] [wait milliseconds] [no-dns] [source ip-address]
[tos type-of-service] [router router-instance]
Context <GLOBAL>
Description The TCP/IP traceroute utility determines the route to a destination address. Note that aborting a trac-
eroute with the <Ctrl-C> command could require issuing a second <Ctrl-C> command before the
prompt is returned.
A:ALA-1# traceroute 192.168.xx.xx4
traceroute to 192.168.xx.xx4, 30 hops max, 40 byte packets
A:ALA-1#
Parameters ip-address | dns-name — The remote address to traceroute. The IP address or the DNS name (if DNS
ttl ttl — The maximum Time-To-Live (TTL) value to include in the traceroute request, expressed as a
wait milliseconds — The time in milliseconds to wait for a response to a probe, expressed as a
no-dns — When the no-dns keyword is specified, a DNS lookup for the specified host name will not
source ip-address — The source IP address to use as the source of the probe packets in dotted
tos type-of-service — The type-of-service (TOS) bits in the IP header of the probe packets, expressed
router router-instance — Specifies the router name or service ID.
Page 70
1 192.168.xx.xx4 0.000 ms
name resolution is configured) can be specified.
Values ipv4-address
ipv6-address
decimal integer.
Values
1 — 255
decimal integer.
Default 5000
Values
1 — 60000
be performed.
Default
DNS lookups are performed
decimal notation. If the IP address is not one of the device's interfaces, an error is returned.
as a decimal integer.
Values 0 — 255
Values
router-name:
service-id:
Default
Base
7210 SAS M, T, X, R6 Basic System Configuration Guide
0.000 ms 0.000 ms
a.b.c.d
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 .. FFFF]H
d: [0 .. 255]D
Base, management
1 — 2147483647