Hummer H1 Service Manual page 84

____________________________________________________________________
®
40. Working under vehicle, loosen, disconnect, or remove
following:
• Remove skid plate.
• Remove starter and shield (with aid of helper).
• Remove exhaust pipe. Also loosen and move heat shield
aside.
• Remove converter housing access cover and gasket.
• Remove oil filter and disconnect lines to oil cooler.
• Remove transmission fill tube Figure 2-58.
• Remove torque converter attaching bolts Figure 2-57.
• Remove nuts attaching engine mount insulators to frame
brackets.
41. Remove turbocharger.
42. Support transmission with floor jack. Position wood
blocks between transmission and jack saddle.
CONVERTER
FLYWHEEL
Figure 2-57: Converter Bolt Removal/Installation
TRANSMISSION FILL/DIPSTICK TUBE
Figure 2-58: Transmission Dipstick Tube
05745159
TORQUE
CONVERTER
BOLT
SEAL
TRANSMISSION
43. Remove bolts/studs attaching transmission to engine
block.
44. Attach lifting sling to engine (Figure 2-59).
FRONT
OF
SLING
RIGHT SIDE
LIFTING CYLINDER
SLING HEAD (FRONT)
J–33139
LEFT SIDE
CYLINDER
HEAD
LIFTING BRACKET
Figure 2-59: Lifting Bracket to Cylinder Head
Attachment
45. Raise engine with hoist and remove it from engine bay.
CAUTION: Make sure all electrical wires, harnesses, and
fluid lines are disconnected and clear of engine assembly. Do
this before removal to avoid damage.
46. Mount engine on heavy duty engine stand or cradle.
Engine stand should have minimum capacity of 1500 lb
(680 kg).
Engine 2-47
LIFTING BRACKET
PIN