Setting Frequency References Through Key Sequences - Omron SYSDRIVE 3G3MV SERIES User Manual

Basic Operation

5-6-4 Setting Frequency References through Key Sequences

The following description provides information on parameters related to frequency ref-
erence settings through key sequences on the Digital Operator
H Frequency Reference Setting/Display Unit Selection (n035)
• Set the unit of frequency reference and frequency-related values to be set or monitored in n035
through the Digital Operator.
• The frequency reference value will be set in 0.01-Hz increments if the frequency is less than 100 Hz
and 0.1-Hz increments if the frequency is 100 Hz or over.
n035
Frequency Reference
Setting/Display Unit Selection
Setting 0 to 3,999
range
Set Values
Value
0 Less than 100 Hz: 0.01-Hz increments
100 Hz or over: 0.1-Hz increments
1 0.1% increments (Max. frequency: 100%)
2 to 39 1-rpm increments (number of motor poles)
40 to 3,999 Unit setting
The value to be set or monitored at max. frequency
jjjj
Note To display 50.0 for example, set the value to 1500. (See note.)
Note The unit of setting of each parameter and monitor item below varies with the decimal place.
Parameters
n024 to n032: Frequency references 1 through 8 and inching frequency command
n120 through n127: Frequency references 9 through 16
Monitor Items
U-01: Frequency reference monitor
U-02: Output frequency monitor
5-18
Register
Unit of
setting
Description
Three digits
Decimal place
0123 Hex Changes during
operation
1 Default setting
Chapter 5
No
0