Installation Of Remote Controller - Mitsubishi Heavy Industries SRK25GZ-L1 Handbook

Drainage
¡
The drain hose must be fit with a downward slope.
¡
Do not set the drain hose like the following illustrations.
Too high
The end of the
drain hose is
touching
water.
¡
Pour water in the drain pan below the heat exchanger and confirm that the water is drained outside.
¡
If the extension drain hose is indoors, make sure it is insulated using a shielding pipe (not supplied).
5) Securing the Indoor Unit to the Installation Board
Instalation
board
Indoor unit
base lower hook

5.5.2 Installation of remote controller

(1) Mounting method of battery
Uncover the remote control switch, and mount the batteries (UM-4 × 2 pieces) in
the body regularly.
(Fit the poles with the indication marks, , & . without fail)
(2) Fixing to pillar or wall
(a) Conventionally, operate the remote control switch by holding in your hand.
(b) In the case of stationary operation service as by mounting on the holder for
the remote control switch, make sure that the locating place is satisfactory
for access service before installing it.
(c) Avoid installing it on a clay wall etc.
It curves like a wave.
the
Shielding pipe
Drain hose
when a part of the extension drain hose is indoors
Indoor unit
Installation
Hook (2 locations)
Wall
under 5 cm
Smell from
sewerage drains.
The gap to the The end of the
ground is less drain hose is
than 5 cm. touching
sewage drains.
Extension drain hose
board
SCM-HG (2 room)
the
Installing steps
1. Hook the upper part
of the indoor unit to
the installation board.
2. The unit can be
installed simply by
gently pushing in the
lower part.
Battery
Cover
Wood screw
ø3.5 × 16
Holder (remote control switch)
Adjust the installation to vertical attitude.
Avoid projecting the screw head.
205