Attachment of ceiling material
Ceiling material can be attached to the panel inner frame.
(Plate thickness max. 15mm)
Ornament panel
Attachment procedures
1 Remove the stopper.
2 Remove the ornament plate and attach the ceiling material.
3 Hold down the ceiling material and return the stopper in position.
Note (1) If the ceiling material is attached, the ornament plate is not used.
14.5.2 Installation of remote controller
Same as the cooling/heating equipment for FDT(N) heat pump type. Refer to page 337.
14.5.3 Installation of outdoor unit
Same as the cooling/heating equipment for FDT(N) heat pump type. Refer to page 338.
14.6 MAINTENANCE DATA
Same as the cooling/heating equipment for FDT(N) heat pump type. Refer to page 348.
Panel inner frame
Stopper
Ceiling material
FDR-H
577