Mitsubishi Heavy Industries SRK25GZ-L1 Handbook page 857

FDC-HKX
2 Mount the two (M5 x 35) panel mounting screws to the indoor unit
A
Detail of Section A
3 Hang the panel on the two mounting screws on the indoor unit by using the two shaped holes. Slide the panel approximately 10
mm. Use the 5 panel mounting screws to secure the panel.
Sliding direction
4 Use the opening to connect the connectors for the louver motor and limit switches.
Opening
Connector
Ceiling opening
5 Reinstall the wind shield plate.
(c) Installation on higher ceiling
Adhere the insulation materials on the blow outlet of the indoor unit. All others are same as the standard installation.
855