Operation Section - Mitsubishi Heavy Industries SRK25GZ-L1 Handbook

SRK-H
(4) Operation control function by remote control switch
¡ 32, 40 models
Remote control switch
S Operation section
FAN SPEED button
Each time the button is pushed, the •
indicator is switched over in turn.
TEMPERATURE button
This button sets the room temperature.
SET TIMER button
This button sets the ON timer and OFF
timer times.
S Indication section
TEMPERATURE Indicator
Indicates set temperature.
(Does not indicate temperature when
operation mode is on AUTO)
FAN SPEED Indicator
Indicates set air flow rate with • lamp.
Unit indication section
TIMER
68
CONT
AUTO
HI
MED
LO
ON OFF TIMER
FAN / SPEED ON / OFF MODE
TEMP AIR FLOW
SET TIMER TIMER
• The above illustration shows all controls, but
in practice only the relevant parts are shown.
CONT
AUTO
HI
MED
LO
ON OFF TIMER
RUN
SRK408HENF
OPERATION MOOD select button
Each time the button is pushed, the •
indicator is switched over in turn.
ON/OFF button
Press for starting operation, press again
for stopping.
AIRFLOW button
This button changes the flap mode.
When pressed, this button changes
the mode in the following order:
(AUTO)
no indication
(SWING STOPPED)
ACL
TIMER button
This button changes the selection of
ON timer/OFF timer operation and
normal operation.
RESET switch
Switch for resetting microcomputer.
OPERATION MODE Indicator
Indicates selected operation with • lamp.
(AUTO) · (Cool) ·
AIR FLOW Indicator
Shows selected flap mode.
TIMER Indicator
RUN (HOT KEEP) light (green)
• Illuminates during operation.
•Blinks at air flow stop due to the 'HOT
KEEP'.
TIMER light (yellow)
Illuminates during TIMER operation.
or
(SWING)
(Heat) · (Dry)