Installation Of Outdoor Unit - Mitsubishi Heavy Industries SRK25GZ-L1 Handbook

FDFL-H
(4) Installation of remote controller (on the main unit)
Attached remote controller may be installed on the main unit as shown below. The work can be done on the spot when the customer
asks so or by other reasons.
Refer to the next page when it is installed on the wall.
necessary parts (Prepare following parts on the spot.)
¡Tapping screw (M4 × L12) × 2 pcs. ¡Tie band ¡Vinyl tape
(a) Boring of mounting hole on the front panel
Remote the front panel and bore the hole of follow-
ing size.
Lace (made of plastics)
Front panel
(d) Wiring of remote controller cables
¡ Use the attached cables and connect between the remote
controller and the terminals (X-red, Y-white, Z-black)
of control box.
¡ Make sure to give an extra length of about 50 cm to the
cables.(Because the front panel may be removed for
maintenance.)
¡ Peel the cable cover as shown below and solder the wires
on the terminals. (Unless they are soldered, they may
become loose.)
(f) Arrangement of cables
Fasten the excessive length of the cable with the tie
bands.
Tie band
Clamp

17.5.2 Installation of outdoor unit

Same as the cooling/heating equipment for FDT(N) heat pump type. Refer to page 338.
17.6 MAINTENANCE DATA
Same as the cooling/heating equipment for FDT(N) heat pump type. Refer to page 348.
676
A
Section A Detail
Lace (made of plastics)
Wiring hole
ø16 ~ ø20
(Debarring)
17.5
2-ø2.87
60 ± 0.5 50
(Trapping
prepared hole)
10 ~ 15mm 10 mm Peel the cover and solder.
To control box
(b) Protection of edge
Make smooth the periphery of the 16 ~ 20 hole with
vinyl tape, etc.
(this is indispensable to protect cables.)
Tape
(c) Installation of remote controller
Install the lower case with tapping screws (M4 ×
L12).
Tapping screw (2pcs.)
(e) Installation of front panel
Take out the cables through the insulating section of
the drain pan.
(g) Installation of side panel
The work is completed when the side panel is in-
stalled.
Remote
controller
Tape